This page was exported from Valid Premium Exam [ http://premium.validexam.com ] Export date:Sun Nov 10 3:18:16 2024 / +0000 GMT ___________________________________________________ Title: Released Cisco 300-615 Updated Questions PDF [Q81-Q98] --------------------------------------------------- Released Cisco 300-615 Updated Questions PDF 300-615 Dumps and Practice Test (162 Exam Questions) NO.81 A request to activate the port security database is rejected. Which action do you perform to investigate the cause of the issue?  Enable the auto-learning feature.  Use the force option to identify rejected devices.  Find conflicting entries between the active and configuration databases.  Verify that devices are fully attached to the active database. NO.82 Refer to the exhibit.An engineer must connect N2K-Fex-1 and N5K-Core-1 so that the traffic flow between the two devices uses load balancing. After inspecting the statistics of the interconnecting interfaces, the engineer concludes that only one link is used. Which action resolves the problem?  Configure source-destination load balancing on N5K-Core-1.  Configure each uplink to be a member of a separate LACP port channel.  Configure the pinning max-link as 2.  Configure destination-mac load balancing on N5K-Core-1 Explanationhttps://www.cisco.com/c/m/en_us/techdoc/dc/reference/cli/n5k/commands/pinning-max-links.htmlNO.83 Refer to the exhibit.Refer to the exhibit. An engineer discovered a VFC interface in a down state on a Cisco Nexus Switch. Which action resolves the problem?  Change the cable between the switch and the server  Reset the Cisco Nexus port toward the file server  Update the CNA firmware and driver versions  Modify the fip keepalive message time to 30 seconds Reference:https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/troubleshooting/guide/ N5K_Troubleshooting_Guide/n5K_ts_fcoe.htmlNO.84 Refer to the exhibit. The EEM script overrides all events in the system policy. What should be added to the script to resolve the issue?  event statement  environment variable  event-default action statement  configure terminal action Section: AutomationNO.85 Refer to the exhibit.An engineer discovers that if the vPC peer link goes down, half of the devices in VLAN 20 experience connectivity issues with the external networks Which action resolves the issue?  Configure a dedicated Layer 3 link between vPC peers  Allow non-vPC VLANs on a second trunk between the two vPC peers  Add the non-vPC SVIs in the dual-active exclude VLAN list  Exclude the non-vPC VLANs from vPC peer link NO.86 An engineer must upgrade all components in a Cisco UCS domain to the same package version, but the upgrade process fails to complete. Which set of Auto Install actions resolves the problem?  Install Infrastructure Firmware, then Install Server Firmware.  Install infrastructure Firmware, then Install Hypervisor Firmware.  Install Hypervisor Firmware, then Install Infrastructure Firmware  Install Server Firmware, then Install Infrastructure Firmware Explanationhttps://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/firmware-mgmt/gui/2-5/b_GUI_Firmware_MaNO.87 An engineer enables the packet postcards feature on a Cisco Nexus 9000 Series Switch but receives the error message “Error: Cannot configure postcard when inband-telemetry is configured.” Which action resolves the issue?  Disable the telemetry feature  Disable the software-telemetry feature  Disable the hardware-telemetry feature  Disable the inband-telemetry feature Explanationhttps://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/93x/progammability/guide/b-cisco-nexNO.88 An engineer is troubleshooting issues in Cisco UCS Director. Drag and drop the possible causes from the left onto the correct issues on the right. NO.89 An engineer is troubleshooting issues in Cisco UCS Director. Drag and drop the possible causes from the left onto the correct issues on the right. NO.90 A user reports that they cannot reach from a UCS server to an FC Storage array. Which command is used to test communication between an FCF and a target?  fcroute  traceroute  fcping  ping Section: Storage NetworkNO.91 Refer to the exhibit.During implementation of a Cisco UCS C-Series Server, an engineer receives the status that is shown in the exhibit. Which action resolves the issue.  Reconfigure the Drive Type from “Removable” to “Non-Removable”  Insert an SD card into SLOT-2  Configure the RAID that is associated with the card.  Set SLOT-1 Sync Mode to “Auto” NO.92 Refer to the exhibit.The vPC between switch1 and switch2 does not work. Which two actions resolve the problem? (Choose two.)  Configure the IP address on the interface.  Activate VLANs on the vPC.  Configure one of the switches as primary for the vPC.  Correct the configuration of the vPC peer link and the vPC peer keepalive.  Match the vPC domain ID between the two devices. ExplanationBoth “vPC peer link” and “Peer keepalive link” are down. So, D is correct.SW1 is using vPC domain ID 500, which SW2 is using 20. They must match. So, E is correct.NO.93 A network engineer discovers a DNS resolution problem on a device that is using the Cisco Nexus Bash shell.The device name is app with an IP address of 10.10.10.1. The primary server IP address is 172.16.10.1 and the secondary server IP address is 172.16.10.2. When the abc.com resolution fails, it should attempt to use efg.com. Which settings must be added to resolv.conf file to resolve the issue?  Option A  Option B  Option B  Option D NO.94 An engineer must upgrade all components in a Cisco UCS domain to the same package version, but the upgrade process fails to complete. Which set of Auto Install actions resolves the problem?  Install Infrastructure Firmware, then Install Server Firmware.  Install infrastructure Firmware, then Install Hypervisor Firmware.  Install Hypervisor Firmware, then Install Infrastructure Firmware  Install Server Firmware, then Install Infrastructure Firmware Explanationhttps://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/firmware-mgmt/gui/2-5/b_GUI_Firmware_MaNO.95 A Cisco UCSB-Series Blade Server is configured to boot a VMwareESXi host from an EMC VNX storage array by using a Fibre Channel SAN. The boot order is confirmed to be configured as expected but the server fails to boot from the SAN. Which action reserves the problem?  Set the same WWPN pools for vHBA adapters  Set the boot LUN to the highest LUN ID in the storage array  Set the boot LUN to the lowest LUN ID in the storage array  Set the same WWNN pools for vHBA adaptor NO.96 DRAG DROPDrag and drop the Cisco UCS SNMP fault types from the left onto the correct issues on the right.Select and Place: Section: Compute PlatformsNO.97 Refer to the exhibit. An engineer deploys a SAN environment with two interconnected Cisco MDS 9000 Series Switches. When the engineer attempts a zone merge, it fails with the error that is presented in the exhibit.Which action resolves the issue?  Import or export a zone set between the switches to synchronize the switches.  Change the name of one of the zones to match the other zone set.  Ensure that the zone members have different names.  Set the distribute policy of the zone to full. Section: Storage NetworkExplanation/Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/troubleshooting/guide/ N5K_Troubleshooting_Guide/n5K_ts_sans.htmlNO.98 An engineer troubleshoots a failed DCBX exchange between a server and a Cisco Nexus switch. Which action allows DCBX to successfully negotiate?  Enable ETS.  Enable PFC.  Enable Cisco Discovery Protocol.  Enable LLDP. Section: Storage Network Loading … 300-615 Exam Dumps Pass with Updated 2022 Certified Exam Questions: https://www.validexam.com/300-615-latest-dumps.html --------------------------------------------------- Images: https://premium.validexam.com/wp-content/plugins/watu/loading.gif https://premium.validexam.com/wp-content/plugins/watu/loading.gif --------------------------------------------------- --------------------------------------------------- Post date: 2022-11-30 16:27:07 Post date GMT: 2022-11-30 16:27:07 Post modified date: 2022-11-30 16:27:07 Post modified date GMT: 2022-11-30 16:27:07