Check Real Juniper JN0-649 Exam Question for Free (2022) [Q31-Q51] : Valid Premium Exam : http://premium.validexam.com

QUESTION 31
Referring to the exhibit, which statement is true?

Only 802. 1X authentication will be used for devices connecting to ge-0/0/15

The current device is authenticated using MAC RADIUS

Additional users will automatically be allowed to connect to ge-0/0/15

The current device was allowed after authentication attempts to the RADIUS server failed

QUESTION 32
You are implementing 802.1x authentication in your Layer 2 network. Each user will have a computer and a phone and you must ensure that both device are authenticated individually. In this scenario, which supplicant mode should be used?

Single-secure

Single

Captive-portal

multiple

QUESTION 33
The policy shown in the exhibit is applied as an export policy to your BGP neighborship.
Which action will be taken for route 12.233.45.5?

It will be evaluated by the next policy.

It will be accomplished by term 1.

It will be accepted by term 1.

It will be rejected by term 2.

It will be accepted by the default policy

QUESTION 34
Click the Exhibit button.

You have configured and applied the policer shown in the exhibit to your Junos device.
Which statement is true in this scenario?

Traffic exceeding the committed-burst size will be marked with a loss priority of high.

Traffic exceeding the excess-burst size will be discarded.

Traffic exceeding the committed-information-rate will be rate limited.

Traffic exceeding the committed-burst size will be discarded.

QUESTION 35
Which protocol allows a switch to pass configuration information to an IP phone?

BFD

IPv6

LLDP-MED

VCCP

QUESTION 36
Referring to the log shown in the exhibit, what is the problem with the OSPF adjacency establishment?

The interface IP addresses on the subnet are duplicates.

There is an MDS authentication mismatch.

The referenced IP address does not exist on the network segment.

The OSPF database description packet is malformed.

QUESTION 37
You have configured MSTP in your Layer 2 network.
You are having problems with it establishing correctly.
Referring to the exhibit, what is causing the problem?

You must assign a context ID number other than zero

The MSTI-to-VLAN mapping does not match

The region name is not correct

The revision number is the same on both devices

QUESTION 38
You are troubleshooting an EVPN-VXLAN IP fabric and observe the loop shown in the exhibit.
Which two steps would you take to further troubleshoot this problem? (Choose two.)

Verify that the same ESI is configured on the link from the host and that it matches the source.

Issue the show route table bgp.evpn.0 command on Leaf2 and verify that Type 4 routes are present.

Issue the show route table bgp.evpn.0 command on Leaf2 and verify that Type 3 routes are present.

Verify that the same ESI is configured on the two links from the source.

QUESTION 39
Referring to the exhibit, a RMSM network is set up to enable communication between multicast devices.
Which statement is true in this scenario?

After the formation of the shortest-path tree, a join message is sent from R2 to R1.

After the formation of the shortest-path tree, a join message is sent from R1 to R5

After the formation of the shortest-path tree, a prune message is sent from R1 to R2.

After the formation of the shortest-path free, a prune message is sent from R1 to R5.

QUESTION 40
You are deploying IP phones in your Layer 2 network and are asked to ensure that the switch sends VLAN and CoS information to the IP phones automatically.
In this scenario, which protocol should be used?

PoE

PoE+

LLDP

LLDP_MED

QUESTION 41
Which statement is correct about IS-IS?

IS-IS uses areas and an autonomous system.

Level 1/2 routers automatically inject a default route to the nearest Level 1 router.

Level 2 routers must share the same area address.

Level 1 routers route traffic between autonomous systems.

QUESTION 42
A BA classifier, input policer, and a multifield classifier are applied to an interface in which order are these features processed?

policer -> BA classifier -> multifield classifier

BA classifier -> multifield classifier -> policer

multifield classifier -> BA classifier -> policer

policer > multifield classifier -> BA classifier

QUESTION 43
You are troubleshooting a route problem in the topology shown in the exhibit. The 10.30.0 0/24 route is not reachable from the R3 router. What would cause this problem?

R3 does not have a route to the BGP next hop of 10.30.0.0/24

R4 is not advertising the 10.30.0.0/24 route to R3

R3 does not have an established BGP session with R4.

R3 does not have an OSPF route for 10.30.0.0/24

QUESTION 44
Which address range is used for source-specific multicast?

239.0.0.0/8

233.0.0.0/8

232.0.0.0/8

224.2.0.0/16

QUESTION 45
You have deployed the access control configuration to the distribution switch.

Referring to the exhibit, which statement is true?

All hosts connected to the access switch will have access to the work after one device authenticates.

All hosts connected to the access switch require authentication to access the network.

Only the first host to authenticate will have access to the network; other hosts will be blocked.

All hosts connected to the access switch will have access to the network without authentication.

QUESTION 46
Your Net is learning the 210.210.40.0/24 route from Provider A and Provider B YourNet would like to forward traffic destined to the 210.210.40.0/24 networking using Provider B.
Referring to the exhibit, how would you accomplish this task?

Add the well-known no-export community to the routes learned through R2.

Apply an export policy to R1’s IBGP peers to set a higher local preference.

Add the well-known no-export community to the routes learned through R1.

Apply an export policy to R2’s IBGP peers to set a Their local preference.

QUESTION 47
Which three databases are used by the Dijkstra algorithm? (Choose three.)

Tree database

Link State Database

Candidate database

MAC database

Configuration database

QUESTION 48
You enable the Multiple VLAN Registration Protocol (MVRP) to automate the creation and management of virtual LANs.
Which statement is correct in this scenario?

The forbidden mode does not register or declare VLANs.

When enabled, MVRP affects all interfaces.

Timers dictate when link state changes are propagated.

MVRP works with RSTP and VSTP.

QUESTION 49
Your EX Series switch has IP telephones and computers connected to a single switch port. You are considering implementing the voice VLAN feature to help with this setup. In this scenario, which two statements are correct? (Choose two.)

The voice VLAN feature must be used with LLDP-MED to associate VLAN ID and 802.1p values with the traffic.

The interfaces must be configured as access ports.

Assigning the incoming voice and data traffic to separate VLANs enables the ability to prioritize the traffic using CoS.

The voice VLAN feature will enable incoming tagged data and voice traffic to be associated with separate VLANs.

QUESTION 50
You want to create an OSPF area that only contains intra-area route information in the form of Type 1 and Type 2 LSAs.
In this scenario, which area is needed to accomplish this task?

totally non-to-stubby area

totally stubby area

stub area

non-to-stubby area

QUESTION 51
Which three types of ports are used for Junos Fusion Enterprise? (Choose three. )

extended port

authenticated port

cascade port

uplink port

designated port

Check Real Juniper JN0-649 Exam Question for Free (2022) [Q31-Q51]

Juniper JN0-649 Exam Syllabus Topics: