The Best Fortinet NSE4_FGT-7.0 Study Guides and Dumps of 2024 [Q50-Q73]

admin NSE4_FGT-7.0 Fortinet January 6, 2024

Rate this post

The Best Fortinet NSE4_FGT-7.0 Study Guides and Dumps of 2024

Top Fortinet NSE4_FGT-7.0 Exam Audio Study Guide! Practice Questions Edition

Fortinet NSE4_FGT-7.0 Exam is an advanced certification that requires a thorough understanding of network security concepts and hands-on experience with Fortinet products. NSE4_FGT-7.0 exam consists of 60 multiple-choice questions, and candidates must achieve a score of 70% or higher to pass. NSE4_FGT-7.0 exam is available in multiple languages and can be taken at a Fortinet Authorized Training Center or online. Upon passing the exam, candidates receive the Fortinet NSE 4 certification, which is valid for two years and can be renewed by passing a recertification exam or obtaining higher-level Fortinet certifications.

NEW QUESTION 50
Refer to the exhibit showing a debug flow output.

Which two statements about the debug flow output are correct? (Choose two.)

The debug flow is of ICMP traffic.

A firewall policy allowed the connection.

A new traffic session is created.

The default route is required to receive a reply.

NEW QUESTION 51
If the Issuer and Subject values are the same in a digital certificate, which type of entity was the certificate issued to?

A CRL

A person

A subordinate CA

A root CA

NEW QUESTION 52
What inspection mode does FortiGate use if it is configured as a policy-based next-generation firewall (NGFW)?

Full Content inspection

Proxy-based inspection

Certificate inspection

Flow-based inspection

NEW QUESTION 53
Which three options are the remote log storage options you can configure on FortiGate? (Choose three.)

FortiCache

FortiSIEM

FortiAnalyzer

FortiSandbox

FortiCloud

NEW QUESTION 54
Refer to the exhibit.

Which contains a session diagnostic output. Which statement is true about the session diagnostic output?

The session is in SYN_SENT state.

The session is in FIN_ACK state.

The session is in FTN_WAIT state.

The session is in ESTABLISHED state.

NEW QUESTION 55
Refer to the FortiGuard connection debug output.

Based on the output shown in the exhibit, which two statements are correct? (Choose two.)

A local FortiManager is one of the servers FortiGate communicates with.

One server was contacted to retrieve the contract information.

There is at least one server that lost packets consecutively.

FortiGate is using default FortiGuard communication settings.

NEW QUESTION 56
Examine the network diagram shown in the exhibit, then answer the following question:

Which one of the following routes is the best candidate route for FGT1 to route traffic from the Workstation to the Web server?

172.16.0.0/16 [50/0] via 10.4.200.2, port2 [5/0]

0.0.0.0/0 [20/0] via 10.4.200.2, port2

10.4.200.0/30 is directly connected, port2

172.16.32.0/24 is directly connected, port1

NEW QUESTION 57
Which CLI command will display sessions both from client to the proxy and from the proxy to the servers?

diagnose wad session list

diagnose wad session list | grep hook-pre&&hook-out

diagnose wad session list | grep hook=pre&&hook=out

diagnose wad session list | grep “hook=pre”&”hook=out”

NEW QUESTION 58
Refer to the exhibit.

Which contains a network diagram and routing table output.
The Student is unable to access Webserver.
What is the cause of the problem and what is the solution for the problem?

The first packet sent from Student failed the RPF check.
This issue can be resolved by adding a static route to 10.0.4.0/24 through wan1.

The first reply packet for Student failed the RPF check.
This issue can be resolved by adding a static route to 10.0.4.0/24 through wan1.

The first reply packet for Student failed the RPF check.
This issue can be resolved by adding a static route to 203.0.114.24/32 through port3.

The first packet sent from Student failed the RPF check.
This issue can be resolved by adding a static route to 203.0.114.24/32 through port3.

NEW QUESTION 59
Refer to the exhibit to view the application control profile.

Users who use Apple FaceTime video conferences are unable to set up meetings.
In this scenario, which statement is true?

Apple FaceTime belongs to the custom monitored filter.

The category of Apple FaceTime is being monitored.

Apple FaceTime belongs to the custom blocked filter.

The category of Apple FaceTime is being blocked.

NEW QUESTION 60
Refer to the exhibit.

Based on the administrator profile settings, what permissions must the administrator set to run the diagnose firewall auth list CLI command on FortiGate?

Custom permission for Network

Read/Write permission for Log & Report

CLI diagnostics commands permission

Read/Write permission for Firewall

NEW QUESTION 61
A network administrator wants to set up redundant IPsec VPN tunnels on FortiGate by using two IPsec VPN tunnels and static routes.
* All traffic must be routed through the primary tunnel when both tunnels are up
* The secondary tunnel must be used only if the primary tunnel goes down
* In addition, FortiGate should be able to detect a dead tunnel to speed up tunnel failover Which two key configuration changes are needed on FortiGate to meet the design requirements? (Choose two,)

Configure a high distance on the static route for the primary tunnel, and a lower distance on the static route for the secondary tunnel.

Enable Dead Peer Detection.

Configure a lower distance on the static route for the primary tunnel, and a higher distance on the static route for the secondary tunnel.

Enable Auto-negotiate and Autokey Keep Alive on the phase 2 configuration of both tunnels.

NEW QUESTION 62
How does FortiGate act when using SSL VPN in web mode?

FortiGate acts as an FDS server.

FortiGate acts as an HTTP reverse proxy.

FortiGate acts as DNS server.

FortiGate acts as router.

NEW QUESTION 63
An administrator must disable RPF check to investigate an issue.
Which method is best suited to disable RPF without affecting features like antivirus and intrusion prevention system?

Enable asymmetric routing, so the RPF check will be bypassed.

Disable the RPF check at the FortiGate interface level for the source check.

Disable the RPF check at the FortiGate interface level for the reply check.

Enable asymmetric routing at the interface level.

NEW QUESTION 64
Refer to the exhibit.

The exhibit contains the configuration for an SD-WAN Performance SLA, as well as the output of diagnose sys virtual-wan-link health-check.
Which interface will be selected as an outgoing interface?

port2

port4

port3

port1

NEW QUESTION 65
Which statement is correct regarding the inspection of some of the services available by web applications embedded in third-party websites?

The security actions applied on the web applications will also be explicitly applied on the third-party websites.

The application signature database inspects traffic only from the original web application server.

FortiGuard maintains only one signature of each web application that is unique.

FortiGate can inspect sub-application traffic regardless where it was originated.

NEW QUESTION 66
An administrator is configuring an IPsec VPN between site A and site B.
The Remote Gateway setting in both sites has been configured as Static IP Address. For site A, the local quick mode selector is 192.168.1.0/24 and the remote quick mode selector is 192.168.2.0/24.
Which subnet must the administrator configure for the local quick mode selector for site B?

192.168.1.0/24

192.168.0.0/24

192.168.2.0/24

192.168.3.0/24

NEW QUESTION 67
Which statement about the policy ID number of a firewall policy is true?

It changes when firewall policies are reordered.

It represents the number of objects used in the firewall policy.

It is required to modify a firewall policy using the CLI.

It defines the order in which rules are processed.

NEW QUESTION 68
Which statement regarding the firewall policy authentication timeout is true?

It is an idle timeout. The FortiGate considers a user to be “idle” if it does not see any packets coming from the user’s source IP.

It is a hard timeout. The FortiGate removes the temporary policy for a user’s source IP address after this timer has expired.

It is an idle timeout. The FortiGate considers a user to be “idle” if it does not see any packets coming from the user’s source MAC.

It is a hard timeout. The FortiGate removes the temporary policy for a user’s source MAC address after this timer has expired.

NEW QUESTION 69
Which two statements ate true about the Security Fabric rating? (Choose two.)

It provides executive summaries of the four largest areas of security focus.

Many of the security issues can be fixed immediately by clicking Apply where available.

The Security Fabric rating must be run on the root FortiGate device in the Security Fabric.

The Security Fabric rating is a free service that comes bundled with alt FortiGate devices.

NEW QUESTION 70
An organization’s employee needs to connect to the office through a high-latency internet connection.
Which SSL VPN setting should the administrator adjust to prevent the SSL VPN negotiation failure?

Change the session-ttl.

Change the login timeout.

Change the idle-timeout.

Change the udp idle timer.

NEW QUESTION 71
Which of the following are valid actions for FortiGuard category based filter in a web filter profile ui proxy-based inspection mode? (Choose two.)

Warning

Exempt

Allow

Learn

NEW QUESTION 72
Refer to the exhibit.

Given the interfaces shown in the exhibit. which two statements are true? (Choose two.)