Latest NSE7_SDW-6.4 Study Guides 2022 – With Test Engine PDF [Q11-Q27]

admin NSE7_SDW-6.4 Fortinet September 20, 2022

Rate this post

Latest NSE7_SDW-6.4 Study Guides 2022 – With Test Engine PDF

Get New NSE7_SDW-6.4 Practice Test Questions Answers

NEW QUESTION 11
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)

It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.

It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.

It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.

NEW QUESTION 12
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)

SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom

The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces

The implicit rule overrides all other rules because parameters widely cover sources and destinations.

The initial session of an application goes through a learning phase in order to apply the correct rule

NEW QUESTION 13
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)

It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.

It improves SD-WAN performance on the managed FortiGate devices.

It sends probe signals as health checks to the beacon servers on behalf of FortiGate.

It acts as a policy compliance entity to review all managed FortiGate devices.

It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

NEW QUESTION 14
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )

It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.

It improves SD-WAN performance on the managed FortiGate devices.

It sends probe signals as health checks to the beacon servers on behalf of FortiGate.

It acts as a policy compliance entity to review all managed FortiGate devices.

It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

NEW QUESTION 15
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )

It improves SD-WAN performance on the managed FortiGate devices.

It simplifies the deployment and administration of SD-WAN on managed FortiGate devices

It sends probe signals as health checks to the beacon servers on behalf of FortiGate

It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server

It acts as a policy compliance entity to review all managed FortiGate devices

NEW QUESTION 16
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?

The 10 Mbps bandwidth is shared equally among the IP addresses.

Each IP is guaranteed a minimum 10 Mbps of bandwidth.

FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.

A single user uses the allocated bandwidth divided by total number of users.

NEW QUESTION 17
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

Set priority 10.

Set cost 15.

Set load-balance-mode source-ip-ip-based.

Set source 100.64.1.1.

NEW QUESTION 18
Refer to the exhibit.

Which statement about the trace evaluation by FomGate is true?

Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.

The packet exceeded the configured bandwidth and was dropped based on the priority configuration.

The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.

Packets exceeding the configured concurrent connection limit are dropped based on the priority configuration.

NEW QUESTION 19
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

The FortiGate cloud key has not been added to the FortiGate cloud portal.

FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

The zero-touch provisioning process has completed internally, behind FortiGate.

FortiGate has obtained a configuration from the platform template in FortiGate cloud.

A factory reset performed on FortiGate.

NEW QUESTION 20
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?

diagnose sys virtual-wan-link health-check

diagnose sys virtual-wan-link log

diagnose sys virtual-wan-link sla-lcg

diagnose sys virtual-wan-link intf-sla-log

NEW QUESTION 21
Which diagnostic command can you use to show the SD-WAN rules interface information and state?

diagnose sys virtual-wan-link neighbor.

diagnose sys virtual-wan-link route-tag-list

diagnose sys virtual-wan-link member.

diagnose sys virtual-wan-link service

NEW QUESTION 22
Refer to exhibits.

Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?

Port1 became dead because no traffic was offload through the egress of port1.

SD-WAN member interfaces are affected by the SLA state of the inactive interface.

Both SD-WAN member interfaces have used separate SLA targets.

The SLA state of port1 is dead after five unanswered requests by the SLA servers.

NEW QUESTION 23
Refer to the exhibit.

Which statement about the command route-tag in the SD-WAN rule is true?

It enables the SD-WAN rule to load balance and assign traffic with a route tag

It tags each route and references the tag in the routing table.

It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.

It ensures route tags match the SD-WAN rule based on the rule order

NEW QUESTION 24
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )

It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance

It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links

It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub

It provides direct connectivity between all sites by creating on-demand tunnels between spokes.

NEW QUESTION 25
Which statement is correct about the SD-WAN and ADVPN?

ADVPN interface can be a member of SD-WAN interface.

Dynamic VPN is not supported as an SD-Wan interface.

Spoke support dynamic VPN as a static interface.

Hub FortiGate is limited to use ADVPN as SD-WAN member interface.

NEW QUESTION 26
What is the lnkmtd process responsible for?

Monitoring links for any bandwidth saturation

Processing performance SLA probes

Flushing route tags addresses

Logging interface quality information

NEW QUESTION 27
Refer to exhibits.

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)