[Dec-2024] Use Real HPE6-A73 Dumps – 100% Free HPE6-A73 Exam Dumps [Q27-Q48]

NEW QUESTION 27
An administrator has configured the following on an AOS-CX switch:

What is the correct ACL rule configuration that would allow traffic from anywhere to reach the web ports on the two specified servers?

NEW QUESTION 28
A network administrator is tasked to set up BGP in the company’s network. The administrator is defining an eBGP peering between an AOS-CX switch and a directly-connected service provider. The administrator has configured the following on the AOS-CX switch:

However, when using the “show bgp all summary” command, the state does not display “Established” for the eBGP peer. What must the administrator configure to fix this issue?

NEW QUESTION 29
A company requires access by all users guests, and employees to be authenticated Employees will be authenticated using 802 1X. whereas guests will be authenticated using captive portal Which type of authentication must be configured on an AOS-CX switch ports where both guests and employees connect?

NEW QUESTION 30
Examine the configuration performed on newly deployed AOS-CX switches;

After performing this configuration the administrator notices that the switch ports always remain in the EAP-start state. What should the administrator do to fix this problem?

NEW QUESTION 31
An administrator of a large campus network needs a solution that will provide root cause analytics to quickly identify problems so that they can quickly be fixed.
Which AOS-CX switch feature should the administrator utilize to help with root cause analytics?

NEW QUESTION 32
A network has two AOS-CX switches connected to two different service providers The administrator is concerned about bandwidth consumption on the service provider links and learned that the service providers were using the company as a transit AS.
Which feature should the administrator implement to prevent this situation?

NEW QUESTION 33
A company has implemented 802 1X authentication on AOS-CX access switches, where two ClearPass servers are used to implement AAA Each switch has the two servers defined A network engineer notices the following command configured on the AOS’CX switches:
radius-server tracking user-name monitor password plaintext arubal23
What is the purpose of this configuration?

NEW QUESTION 34
Examine the network exhibit:

Examine Rome r4″s partial OSPF configuration: router OSPF 1
Area 0
exit interface vlan 100
ip ospf area 0
exit interface vlan 40
ip ospf area 0
exit interface 1/1/1
vlan access 100
mtu9000
Ip ospt hello-Interval 1
Ip ospt dead-Interval 4
ip ospf authentication simple-text
ip ospf authentication-key key123
When executing the “show ip ospf neighbors” command, Router 4 is in a FULL state with Router 3 and Router 2, but a 2-WAY state with Route3. What is causing the 2-WAY state with Router 1?

NEW QUESTION 35
How is voice traffic prioritized correctly on AOS-CX switches?

NEW QUESTION 36
Examine the partial output of the BGP routing table of an AOS-CX switch:

The switch is learning about four possible path to reach the 1.0.0.0/8 network. Based on this output, which next-hop route will the AOS-CX select to be placed in the IP routing table?

NEW QUESTION 37
Examine the attached exhibit.

The network administrators is trying to add a remote location as area 3 to the network shown in the diagram.
Based on current connection restrictions, the administrator cannot connect area 3 directly to area 0. The network is using AOS-CX switches.
Which feature should the administrator implement to provide connectivity to the remote location?

NEW QUESTION 38
A switch will apply a device profile to a port based on which pieces of information? (Select two.)

NEW QUESTION 39
An administrator is configuring BGP and has two connections to a service provider to two different local routers.
Which BGP metric should the administrator configure to influence which local router the service provider will use to reach certain routes?

NEW QUESTION 40
An administrator has an aggregation layer of 8325CX switches configured as a VSX pair. The administrator is concerned that when OSPF network changes occur, the aggregation switches will respond to the changes slowly, and this will affect network connectivity, especially VoIP calls, in the connected access layer switches.
What should the administrator do on the aggregation layer switches to alleviate this issue?D18912E1457D5D1DDCBD40AB3BF70D5D

NEW QUESTION 41
A network administrator needs to replace an antiquated access layer solution with a modular solution involving AOS-CX switches. The administrator wants to leverage virtual switching technologies. The solution needs to support high-availability with dual-control planes.
Which solution should the administrator implement?

NEW QUESTION 42
How does an administrator install a script and create an agent and actions for the Network Analysis Engine running on AOS-CX switches?

NEW QUESTION 43
What is correct regarding rate limiting and egress queue shaping on AOS-CX switches?

NEW QUESTION 44
Examine the configuration performed on newly deployed AOS-CX switches:

After performing this configuration, the administrator notices that the switch ports always remain in the EAP start state. What should the administrator do to fix this problem?

NEW QUESTION 45
The AOS-CX mobile app allows a network engineer or technician to perform which tasks? (Choose two.)

NEW QUESTION 46
A company has implemented 802.1X authentication on AOS-CX access switches, where two ClearPass servers are used to implement AAA. Each switch has the two servers defined. A network engineer notices the following command configured on the AOS-CX switches:
radius-server tracking user-name monitor password plaintext aruba123
What is the purpose of this configuration?

NEW QUESTION 47
Examine the partial output of the BGP routing table of an AOS-CX switch:

The switch is learning about four possible path to reach the 1.0.0.0/8 network. Based on this output, which next-hop route will the AOS-CX select to be placed in the IP routing table?

NEW QUESTION 48
How is voice traffic prioritized correctly on AOS-CX switches?