Easily To Pass New NACE NACE-CIP1-001 Dumps with 100 Questions [Q19-Q38]

NO.19 A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

NO.20 The most important factor resulting in improved job site safety is:

NO.21 Silicone coatings are typically:

NO.22 The Inspector’s Log Book is generally:

NO.23 The form of corrosion that has the largest potential for unexpected catastrophic failure is:

NO.24 When the joint NACE/SSPC abrasive blast cleaning standards are specified, the pictures in SSPC VIS 1 can be used as:

NO.25 Due to a previous premature coating failure the owner has required the original coating applicator to return to remove and replace 10,000 square feet of a failed three coat system at the applicator’s cost. Due to the financial implications of another failure, the owner has offered you the job as the NACE CIP Level 1 Coating Inspector and explained that he expects you to be his “insurance policy” for this job. You have never been involved in a warranty job before and are unfamiliar with the coating system.
Your preferred FIRST course of action is to:

NO.26 In a non-convertible coating the role of the primary solvent is to:

NO.27 Which one of the following documents is the best source for coating technical data:

NO.28 ISO SA 2.5 is defined as:

NO.29 NACE No. 4/SSPC-SP-7 is a joint standard for

NO.30 When performing tests for oil and grease using an ultra-violet light, the NACE Inspector should be aware that:

NO.31 Removal of surface contaminants is done by:

NO.32 Upon arrival of coating materials, the inspector should

NO.33 On a blast-cleaned surface, Ian ultraviolet light is generally used to detect

NO.34 When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

NO.35 Digital hygrometers

NO.36 What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

NO.37 To be of value the Inspector’s documentation must be:

NO.38 Excessive working of the surface with a power grinder can be detrimental because excessive burnishing