Pass Your NACE-CIP2-001 Dumps as PDF Updated on 2026 With 100 Questions [Q31-Q54]

NEW QUESTION 31
Dehumidification is defined as the removal of moisture vapor from the air to

NEW QUESTION 32
When ASIN D 3363 is specified the Inspector must:

NEW QUESTION 33
Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.

NEW QUESTION 34
In powder coatings, when the particles of powder begin to flow but are not fully liquid, they are in what stage?

NEW QUESTION 35
Inspection and Test plans are developed by referencing:

NEW QUESTION 36
You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

NEW QUESTION 37
The most likely area of failure on a buried external pipeline coating is the:

NEW QUESTION 38
Antifouling coatings are regulated by international treaties.

NEW QUESTION 39
When completing the Final Inspection report the Inspector should write the report using:

NEW QUESTION 40
Differences in technique for abrasive blasting concrete versus steel require the operator to:

NEW QUESTION 41
Linings are used on the interior of pipelines to

NEW QUESTION 42
As a NACE Level 2 Inspector, NACE clearly indicates that you ate qualified to independently produce final documentation for a shop project.

NEW QUESTION 43
WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)

NEW QUESTION 44
A failure caused by applying a coating too thinly is known as

NEW QUESTION 45
Surface preparation methods for Non-ferrous metals are:

NEW QUESTION 46
The number of air turns in an enclosure can be affected by all of these EXCEPT

NEW QUESTION 47
When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

NEW QUESTION 48
NACE/SSPC Water Jetting standards are directly equivalent to ISO Abrasive Blast Standards:

NEW QUESTION 49
Steel shot grit contaminated with oil or grease used in a cetrifugal blast cleaning should be

NEW QUESTION 50
The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cure of

NEW QUESTION 51
You are a NACE Level 2 in-house inspector working in a shop. Your in-house requires you to perform a sleeve test to test for soluble salts; however the 3 rd party NACE Level 3 inspector, the owner, has a san smart meter and has achieved a very different result and has rejected the pre-cleaning.
Your FIRST course of action is to:

NEW QUESTION 52
The primary purpose of Fireproofing coatings are to provide:

NEW QUESTION 53
A single component water borne acrylic coating cures by:

NEW QUESTION 54
Which standards are generally established by private-sector bodies and are available for use by any person or Organization, private or government?